VIEW/DOWNLOAD PRINTABLE MSDS/PDS SHEETS BELOW
MSDS's and PDS's require Adobe Acrobat Reader. Download it for free here.
PDS MSDS

DESCRIPTION
PreFlight is a tool surface conditioner developed to treat both
the chemical and physical bonding sites found on every
"raw" tool surface to prepare for the application of Departure
release agent. This step, which only needs to be taken once
per cleaning cycle, will dramatically increase both the life of the
tool and the performance of the release coating. In addition to
these benefits, you can expect improved appearance of parts
and a reduced need for post finishing.


BENEFITS

  • Provides desirable tool surface attributes
  • Protects and extends useful tool life
  • Increases life of release coating
  • Restores vacuum integrity
  • Ready-to-use dispenser packaging
  • No fumes or bad solvent odors
  • Non-flammable and Non-hazardous
  • No special storage requirements
  • People safe (no gloves or respirators required)
  • ENVIRONMENTALLY SAFE
 TYPICAL PROPERTIES

Appearance/Odor: White liquid/neutral odor
Carrier: Water
Flash Point (c.c.): None

USES
PreFlight is a hard coating specifically formulated to create a barrier on the tool surface providing protection and overcoming micro-porosity problems. PreFlight reduces downtime by increasing the number of molding cycles between cleanings. PreFlight is strongly recommended to restore a uniform tool surface over a repair or patch.

SURFACE PREPARATION
Before applying PreFlight, remove all previous contaminants and release coatings using Fresh Start.

HOW TO USE

  1. Wet applicator cloth with PreFlight and apply a thin coat to small sections. DO NOT WIPE OFF.
  2. Allow 15 minutes cure time before applying second coat.
  3. Wipe on second coat, immediately wipe off. Wait 15 minutes.
  4. Wipe on third coat, immediately wipe off. Wait 15 minutes.
  5. Wipe on fourth coat, immediately wipe off then heat-cure for 15 minutes at 180°F (83°C). The tool surface is now ready for the application of Departure release coating.