VIEW/DOWNLOAD PRINTABLE MSDS/PDS SHEETS BELOW
MSDS's and PDS's require Adobe Acrobat Reader. Download it for free here.
PDS MSDS

FRESH START has been developed for use in the aerospace industry to clean a tool or finished part to a waterbreak-free surface without the use of solvents or other hazardous components. FRESH START is effective in removing most contaminants and semi-permanent release coatings on both new and existing tools. FRESH START can also be used to prepare parts for secondary bonding, painting, or other processing that usually requires a clean surface.

BENEFITS

  • More cleaning power than solvents
  • Visual evidence when surface is clean
  • No Fumes or bad solvent odors
  • Non-flammable and Non-hazardous
  • Ready-to-use dispenser packaging
  • Does not "Flash-off" allowing more time to work
  • People safe (no gloves or respirators required)
  • No special storage requirements
  • Great for C-SCAN and Repair operations
  • ENVIRONMENTALLY SAFE
 TYPICAL PROPERTIES
Appearance/Odor:
Green liquid/neutral odor

Carrier: Water

Flash Point (c.c.): None

USES
FRESH START is recommended for the cleaning of composite and metal tools, equipment, and finished parts to a waterbreak-free surface.

HOW TO USE

  1. Open resealing spout and apply small amount of FRESH START directly onto surface.
  2. Using a cloth or abrasive pad, scrub the surface to loosen any contaminants.
  3. Work on small sections until the entire surface is scrubbed; a pneumatic buffer can be used on large parts.
  4. Thoroughly rinse with water or wipe off and repeat until waterbreak-free surface is achieved.
  5. Reseal pouch when not in use.

    Note: For best results, do not allow FRESH START to dry on surface. Rinse or wipe off thoroughly while product is hydrated.